Jump to content


Photo

ACC / OK3 USB Driver

ACC USB Driver

  • Please log in to reply
2 replies to this topic

#1 mare_imbrium

mare_imbrium

    Member

  • Members
  • 4 posts
  • LocationAachen

Posted 12 May 2019 - 02:48 PM

Hello Forum, I need help with software,
I bought a used ASA 12N year 2010. Unfortunately without software.
I can't get the OKZ to work with the drivers that are stored in the support.
Neither under Windows 10 nor under Windows 7
The USB connector is recognized as a serial interface. However, ACC always responds with a "Device Error". 
The FTDI drivers are installed, everything according to the instructions but unfortunately without success.
I would be very happy about help and support.
Greetings, Thomas
 


#2 Artem

Artem

    Member

  • Beta Tester
  • 52 posts

Posted 13 May 2019 - 06:51 PM

Could it be ? that you have had or did setup another focuser installed or setup and ACC is trying to start it ? and outcome is the error "Device Error".

 

Try to “reset Settings in ACC with ””ACC General Settings”. abd setup the OK3 as your new focusser system.

 

 

 

Good luck and I am only guessing.. :wub: :wub: :wub:

 

Martin



#3 mare_imbrium

mare_imbrium

    Member

  • Members
  • 4 posts
  • LocationAachen

Posted 14 May 2019 - 07:14 PM

Hello, Martin,
thank you very much for your feedback. The ASA 12N is from 2010 and I get
the ASA control box not addressed. You need the software components 
from time (Win Vista or Win7) with Netframework and FTDI drivers.
It depends here on the versions. I am already in contact with the ASA support and hope to be able to purchase a newer control box.
Regards, Thomas






Also tagged with one or more of these keywords: ACC, USB Driver

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users