Wojtek Gdańsk Posted March 1, 2014 Report Share Posted March 1, 2014 (edited) Welcome. What should I do to Fokuser OK3Z work together with the joystick. I had problems with this so maybe someone handy video which shows what you need in Autoslew pozaznaczać to OK3Z began to work with the joystick. 1) You must have already installed the driver and software to OK3Z ACC. 2) Open the ACC and configure it correctly. 3) Confirm there are in the ACC operates fokuser. If it works correctly, close the ACC. 4) Start Autoslew and proceed as shown in the film. Regards, Wojtek. Edited March 1, 2014 by Wojtek Gdańsk Link to comment Share on other sites More sharing options...
MartinN Posted March 26, 2014 Report Share Posted March 26, 2014 Wojtek, thank you for these hints, they enabled me to setup very quickly Focuser operation from the joystick. Especially, the COM-Number-Axis-association (Axis setting below OK3-SM2A) did the trick ! In addition, I set in MaximDL at Observatory Control - Setup - Focuser 1 - Options - Chose... the "AstroOptik Server Focuser", and MaximDL can control the focuser in parallel, for e.g. autofocus. Kind regards Martin Link to comment Share on other sites More sharing options...
Wojtek Gdańsk Posted March 28, 2014 Author Report Share Posted March 28, 2014 Welcome. I'm glad I could help. Regards Wojtek Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now