markusblauensteiner Posted December 3, 2014 Report Share Posted December 3, 2014 Hi! Today, i had to connect my ASA DDM 60 to an USB-extention-cable. For that, i bought two active, 5 m USB 2.0 extentions (good ones!). I stated Autoslew and everything was fine, until the motors and "Autofind" started. Autofind normally takes about 15 seconds, but now it only took about 5 seconds! (for both axes together) I was a little bit scared about that and switched to cheaper, 3m extentions. Since then, everything was "normal" again. I have to say that any functions always worked normal, except Autofind. Did anybody else notice something like that before? Best regards, Markus Link to comment Share on other sites More sharing options...
Question
markusblauensteiner
Hi!
Today, i had to connect my ASA DDM 60 to an USB-extention-cable. For that, i bought two active, 5 m USB 2.0 extentions (good ones!).
I stated Autoslew and everything was fine, until the motors and "Autofind" started.
Autofind normally takes about 15 seconds, but now it only took about 5 seconds! (for both axes together)
I was a little bit scared about that and switched to cheaper, 3m extentions. Since then, everything was "normal" again.
I have to say that any functions always worked normal, except Autofind.
Did anybody else notice something like that before?
Best regards, Markus
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now