charleslillo Posted July 23, 2015 Report Share Posted July 23, 2015 I just acquired an ASA 10N and after reading the website regarding the rings, the website says that they are ready to bold on to a Losmandy plate. I have 2 Losmandy plates and both have a much smaller bolt pattern then the rings do. Are you guys drilling out your rings to the Losmandy bolt pattern or is there a Losnamdy plate out there that will fit with out having to drill out the rings? Any suggestions would be much appreciated. Charles Lillo www.theastrogeeks.com Link to comment Share on other sites More sharing options...
Corpze Posted July 23, 2015 Report Share Posted July 23, 2015 There are imperial as well as metric Losmandy plates to i think... If it only was metric around the world :-( Link to comment Share on other sites More sharing options...
charleslillo Posted July 23, 2015 Author Report Share Posted July 23, 2015 (edited) Thanks Corpze, but I'm referring to the bolt pastern no the bolt size, if that makes sense? On the asa 10in rings, the holes are wider (further apart) than the holes on my losmady plates. Edited July 23, 2015 by charleslillo Link to comment Share on other sites More sharing options...
Corpze Posted July 23, 2015 Report Share Posted July 23, 2015 Oh, i see well, then it is beyond my knowledge i'm afraid. /Daniel Link to comment Share on other sites More sharing options...
charleslillo Posted July 24, 2015 Author Report Share Posted July 24, 2015 Thanks Daniel, I think I found my issue. My saddle is made by ADM and is not a true losmandy saddle. I found a true losmandy saddle and believe it will have the same bolt pattern width i need. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now