astrosirius Posted October 28, 2015 Report Share Posted October 28, 2015 (edited) Hello to everybody, Someone have had this kind of message? " Wrong Encoder Position Error" When I want to do a Autopoint with 84 stars in some positions the mount lose the Encoder position and once I want to do a Park home, the mount it goes where it want. I will appreciate your comments about this Issue. B.r Lluís Romero. http://www.flickr.com/photos/llromero/ Edited October 28, 2015 by astrosirius Link to comment Share on other sites More sharing options...
0 Denis Vien. Posted October 28, 2015 Report Share Posted October 28, 2015 Good evening Romero, I see you have problem after making a scoring model more than 80 stars, it happened to me, it may be that you have not checked on each star error there was, once the 100 number was exceeded, the calculation is wrong. redo a pointing mode fewer stars and checks each time the value does not exceed 100 and De Ar, and see that want to go Sincerely Denis Vienat Link to comment Share on other sites More sharing options...
0 astrosirius Posted October 29, 2015 Author Report Share Posted October 29, 2015 Hello Denis, Thanks a lot for your help. I read yesterday night your message and I restart the Autopoint with 23 Stars, the results has been quite good!! I introduced 40º Horizont and 60º in Altitude to make the model in sequence. But still in some point appears the message, anyway I will try to reduce the values o get better results. I will let you know it the final result. Lluís Romero.http://www.flickr.com/photos/llromero/ Link to comment Share on other sites More sharing options...
0 GeorgeCarey Posted October 29, 2015 Report Share Posted October 29, 2015 Have you done a 'find home position' routine when you switch on the mount? I don't think the problem has anything to do with the number of stars in the pointing model. The ini file should have the correct values for your encoders - it is worth checking this with ASA? Contact Support and send them the ini file. George Link to comment Share on other sites More sharing options...
0 astrosirius Posted October 29, 2015 Author Report Share Posted October 29, 2015 Have you done a 'find home position' routine when you switch on the mount? I don't think the problem has anything to do with the number of stars in the pointing model. The ini file should have the correct values for your encoders - it is worth checking this with ASA? Contact Support and send them the ini file. George Hi George, Yes I have done each time I switch on the mount. Today I have made a pointing model with 22 stars (45 Horizon and 60º Dec) In one of the position has appeared the same message and the mount lost the position. I will do it, thank you for your recommendation. B.r Luis Link to comment Share on other sites More sharing options...
Question
astrosirius
Someone have had this kind of message? " Wrong Encoder Position Error"
When I want to do a Autopoint with 84 stars in some positions the mount lose the Encoder position and once I want to do a Park home, the mount it goes where it want.
I will appreciate your comments about this Issue.
B.r
Lluís Romero.
http://www.flickr.com/photos/llromero/
Edited by astrosiriusLink to comment
Share on other sites
4 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now